Double Scissor Lift DS32 CAT-A

3,2 t, electro-hydraulic

Share on

Description

The low-profile double scissor lift DS32 was especially designed for the servicing area. The flexible loading platforms allow a wide loading range.

  • Full-metal scissors
  • Best corrosion protection as standard
  • Fully hydraulic System
  • Problem-free operation of the extension with level installation.
  • A simple above-ground installation is possible as the lift provides a low clearance height.
  • Rubber pads included in the delivery scope provide reliable protection for the vehicle underbody.
  • The smart design allows the easiest operation of the extension, also with a vehicle above it.
  • With a platform length of up to 2160 mm, the DS32 vehicles can accept up to VW T5/T6 with short wheelbase.
  • The design is distinguished by its utmost stability. The scissors are made of full metal.
  • In matters of rust protection, long life comes first – including standard wet galvanizing with additional powder coating of the platform and of the base frame.
  • The low clearance height of the lift allows vehicles to be supported with little ground clearance.
  • The fully hydraulic system with built-in self-venting ensures a reliable operation even in dirty environments.
  • The pre-assembled control console has a quite hydraulic unit and thus contributes significantly to a low installation expenditure.
  • Documents or tablet computers have their place on the integrated storage area. Also perfectly suited as a writing support.
  • Neatly arranged and stable push buttons ensure safe operation of the lifting platform.
  • User friendliness is the top priority here too, the side parts on all 4 sides are removable, the electrical components are located underneath the foldable control and writing panel.
  • Positioning can occur on the left or the right, the hose length between lifting platform and console is 2 m.
  • To enable flexible accomodation of both small and large vehicles, the DS32 has platform extensions which are foldable on both sides and easily locked.
  • The superfluous double Master-Slave hydraulic system makes it possible to dispense with additional safety latches. Double the safety, thus preventing one-sided lifting or lowering.
  • All hydraulic cylinders are screwable. This increases the user friendliness.
  • The standard CE stop ensures a base protection without deflectors. This also allows an inground installation.
  • An emergency lowering is easily possible in the event of a power failure.

 

Media

Linked Products

Similar

Accessories

Tech Data

FeaturesDouble Scissor Lift DS32 CAT-ADouble Scissor Lift DS35 CAT-A
Scissor lift designDouble scissorsDouble scissors
Mode of driveelectrohydraulicelectrohydraulic
Type of installationfloor mountedfloor mounted
Rated load capacity3200kg3500kg
Lifting height max.1945mm1945mm
Lifting time40s40s
Lowering time40s40s
Drive-on-height105mm105mm
Surface coatingpowder coatedpowder coated
Corrosion preventingCathodic electrodeposition coating (CEC)Cathodic electrodeposition coating (CEC)
Length of runways1500 - 2160mm1500 - 2160mm
Wheel free liftnot possiblenot possible
Driving power3,0kW3,0kW
Power supply400 V | 50 Hz400 V | 50 Hz
Weight885kg885kg